Clean the pump filter
- 1.
Warning: The filter should never be removed during a wash programme, always wait until the wash programme has finished and the laundry has been taken out.
- 2.
Turn the mains water connection to the OFF position to prevent water entering the washing machine.
- 3.
Locate the pump cover, which is usually at the bottom left or right on the front of the washing machine.
- 4.
Place a container or a towel in front of the pump cover, this will prevent any spillage from the remaining water in the washing machine.
- 5.
Open or remove the pump cover.
Note: Your washing machine may have a waste pipe, pull the waste pipe out. Remove or open the cap on the end, then empty any trapped water before opening the pump filter.
- 6.
Turn the pump filter anti-clockwise.
- 7.
Remove the pump filter from its housing.
- 8.
Remove any dirt and blockages, then clean the pump filter with clean water.
- 9.
Place the pump filter back into its housing, then turn the pump filter clock-wise to lock it into place.
Note: if your washing machine has a waste pipe, replace or close the cap and place the waste pipe back into the housing.
- 10.
Close or replace the pump cover.
- 11.
Open the inlet water tap.
- 12.
It is recommended that the pump filter is cleaned every 2-3 months.