• Always check the User Manual for guidance on the safe use of your Magic Bullet. Also refer to the Safety information topics in this guide for information.

    WARNING: The cross blade is very sharp. Handle with care.

    Never leave the Magic Bullet running for more than one minute at a time, or for more than 3 consecutive one minute intervals.

    Never blend heated or carbonated ingredients, this could cause the cup to pressurize and leak.
  • 1.

    Fill the cup 2/3 full with warm soapy water.

  • 2.

    Place the cross blade onto the cup.

  • 3.

    Turn the cross blade clockwise to form a tight seal.

  • 4.

    Plug the power lead into the mains power.

  • 5.

    Line up the tabs on the cup with the tabs on the power base.

  • 6.

    Press the cup down onto the power base and twist the cup clockwise. This will lock the cup into the power base.

    The unit will activate as soon as the cup is pressed down.
  • 7. Let the power base run for about 20-30 seconds.
    Caution: Do not let the extractor blade run for longer than one minute.
  • 8.

    Turn the cup anticlockwise to release the tabs, while holding the power base with your other hand.

  • 9.

    Wait for the power base to stop completely then remove the cup from the power base.

    Removing earlier than this will lead to increased wear on both the extractor blade and power base.
  • 10.

    Remove the power lead from the mains power.

  • 11.

    Turn the cross blade anticlockwise.

  • 12.

    Remove the cross blade.

  • 13.

    Wash the cup and cross blade with warm soapy water and dry thoroughly with a soft dry cloth.

    WARNING: The cross blade is very sharp. Handle with care.

    Never use abrasive cleaning agents.